Panel Beating Services: What is it all about?

July 31, 2017

Panel beating services sound a mite violent, perhaps even chaotic. An image of someone smashing a metal panel with a big hammer comes to mind at first. However, nothing could be further from the truth. For this is an engineering discipline, one that exists to expertly restore damaged vehicle bodywork. Let's delve deep into the specialised skills and tools that define a top-notch panel beating service.

Expert Automobile Bodywork Restorers

Your heart breaks when your car's bodywork is disfigured after a road accident. The once smooth panels are crumpled and creased like a badly wrinkled piece of fabric. That fabric can be cleaned and pressed, but what about those metal panels? That's when you need a professional panel beating service, a garage that uses special tools to restore the metal to its like-new condition. Bodywork hammers, not clawed carpenter hammers, are wielded by trained technicians. They, along with curved dollies, work the malleable panels so that the wrinkles and dents are precisely beaten away.

Going the Panel Beating Extra Mile

A kilometre or a mile, the metaphor serves well as a conveyor of the labour-intensive truth. The service removes bodywork damage, restores the vehicles aesthetic proportions, and generally leaves the car looking like it did before the damage was incurred. The profession-specific tools, including those dollies you just read about, are engineered so that they reshape and reset the curves of the panel. Basically, the predesigned dollies tools are held behind the sheet metal. Then, as the expertly applied beating action commences, that metal panel assumes the same curvilinear outlines as the dolly. The two tools are essentially pushing the panel back into shape.

Applying Finishing Techniques

Again, this is a labour intensive project, and there's a lot of craftsmanship involved. The panel beating process continues until the part is restored. Dents are erased by the tools, scrapes and scratches are filled and sanded. The bodywork trimming is replaced, the fastener holes replaced, and the door locks restored. Alignment problems need correction, too, so it's time to swing over to the wheel and chassis mechanics once the panels are restored. Then, when the bodywork and vehicle frame are repaired, you can take to the road again in a car that looks, if anything, better than it did before the damage was received.

This is one of the oldest, most respected vehicle repair professions on the globe. After all, everything you own seems to be made to be thrown away. Sometimes that approach is unavoidable when a car accident is bad enough. Then the panels need to be replaced. Most times, though, expert panel beating services can and will skillfully beat out the damage and restore the bodywork until the car looks as good as new again.

Optimized by NetwizardSEO.com.au